Glovebox Power Adapters
'Vintage FlashPort' - white flashlight version for 80's BMW's - such as e30, e28, etc.
See glovebox power adapter web page for more information.
See glovebox power adapter web page for more information.
'FlashPort' - black flashlight version for 90's & 2000's BMW's.
See glovebox power adapter web page for more information.
EuroClock Installation Adapters
6 Button OBC - Adapter
Estimated install time: 5 minutes
Estimated install time: 5 minutes
13 Button OBC - Adapter
Estimated install time: 1 hour
Sport BMW Brake & Clutch Pedal Pads
Estimated install time: 5-10 minutes
Quick Start Guide:
1) Remove current pedal pads, prying the back edges by hand.
2) Slide new pedal cover on and stretch to cover. It will be tight.
3) Make sure all the edges are smoothly and completely covering all edges of the pedal face.
4) Drive and enjoy your new pedal pads
1) Remove current pedal pads, prying the back edges by hand.
2) Slide new pedal cover on and stretch to cover. It will be tight.
3) Make sure all the edges are smoothly and completely covering all edges of the pedal face.
4) Drive and enjoy your new pedal pads
Rearview Mirror Stabilizer
Estimated install time: > 5 minutes
Quick Start Guide:
1) Loosen both side thumb nuts, clean glass where suction cup will attach
2) Remove thumb nut from side with open C shape (this side will go around the mirror stalk)
3) Place stabilizer behind the mirror with suction cup facing glass - with C shape going around stalk - position with two hands on either side
4) Reach around and screw missing thumb nut on to screw and screw until almost snug
- Note: At this point the clamp should be around the stalk, almost snug on both sides
5) Wiggle unit into best position behind mirror and clamp suction cup to glass
6) Tighten thumb screws
7) Tighten center wheel around ball joint
8) Tighten all items thumb tight - do not over tighten, just needs to be snug
9) Drive and enjoy your view not shaking!
See rearview mirror stabilizer web page for more information.
1) Loosen both side thumb nuts, clean glass where suction cup will attach
2) Remove thumb nut from side with open C shape (this side will go around the mirror stalk)
3) Place stabilizer behind the mirror with suction cup facing glass - with C shape going around stalk - position with two hands on either side
4) Reach around and screw missing thumb nut on to screw and screw until almost snug
- Note: At this point the clamp should be around the stalk, almost snug on both sides
5) Wiggle unit into best position behind mirror and clamp suction cup to glass
6) Tighten thumb screws
7) Tighten center wheel around ball joint
8) Tighten all items thumb tight - do not over tighten, just needs to be snug
9) Drive and enjoy your view not shaking!
See rearview mirror stabilizer web page for more information.
Additional Customer Support
Email: info@e30love.com
Web: contact form
Web: contact form